HB-5213 adjustable veneer anchor designed to anchor masonry to concrete, block or brick, accommodating rigid insulation up to 6 inches (75mm) thick.
The compressed leg 2X-HOOK™ has been tested and designed to withstand over 200-lbf, in tension or compression, at maximum allowed offset (ACI 530 188.8.131.52.5.4) of 1-1/4” (disengagement of the pintle from the veneer anchor). These results exceed BIA recommendations and the capabilities of standard “round wire” hooks or pintles by over 100%!
- Furnished with one 7/16”Ø hole for use with 523 Brass Expansion Bolt.
- The L-shaped plate section has numerous ribs for added strength .
- The eyelets allow 2X-HOOK™ (pintle) insertion (1 1/4" maximum allowable eccentricity) and are sized to prevent in-and-out movement beyond allowable tolerances.
- For metal stud construction, use the HB-213.
NOTE: 2X-HOOK™ CAN BE INSTALLED WITH LEGS POINTING UP OR DOWN.
- The embedded portion of the 2X-Hook is 3/16”DIA round wire, satisfying the code requirement that the mortar bed thickness (typically 3/8”) must be twice the diameter of the wire.
- 2X-Hook: U.S. Pat. No. 8,613,175 Test results available upon request.
- Hot-Dip Galvanized
- Stainless Steel (Type 304 or Type 316)
- 2X-HOOK™ lengths: 3” (300H-2X), 4” (400H-2X), 5” (500H-2X), 6” (600H-2X), and 7” (700H-2X)
- H&B recommends 16" x 16" spacing
- Legs fabricated to accommodate up to 6" thick insulation and/or wallboard combination (state thickness when ordering)
Optional: HB-213 Washer to hold insulation to back-up