HB-213 Adjustable Veneer Anchor 14GA Hot Galvanized (Anchor Only-Hook Not Included)

The HB-213 is an adjustable veneer anchor for metal stud and wood stud construction.

The compressed leg 2X-HOOK™ has been tested and designed to withstand over 200-lbf, in tension or compression, at maximum allowed offset (ACI 530 6.2.2.5.5.4) of 1-1/4” (disengagement of the pintle from the veneer anchor). These results exceed BIA recommendations and the capabilities of standard “round wire” hooks or pintles by over 100%!

• The L-shaped plate section has numerous ribs for added strength and 9/32" holes for connecting screws.
• The eyelets allow 2X-HOOK™ (pintle) insertion (1 1/4" maximum allowable eccentricity) and are sized to prevent in-and-out movement beyond allowable tolerances.
• For concrete, CMU or brick backup, use the HB-5213.
• Formerly called the HB-200/DA-213 or HB-200 Adjustable Veneer Anchor
• NOTE: 2X-HOOK™ CAN BE INSTALLED WITH LEGS POINTING UP OR DOWN.
• The embedded portion of the 2X-Hook is 3/16”DIA round wire, satisfying the code requirement that the mortar bed thickness (typically 3/8”) must be twice the diameter of the wire.
• 2X-HOOK™: U.S. Pat. No. 8,613,175 Test results available upon request.

GAUGES:

• 14 ga. or 12 ga. thick

AVAILABLE FINISHES:

• Hot-dipped Galvanized
• Stainless Steel (Type 304 or Type 316)

DIMENSIONS:

• 2X-HOOK™ lengths: 3” (300H-2X), 4” (400H-2X), 5” (500H-2X), 6” (600H-2X), and 7” (700H-2X)

SEISIMIC OPTIONS:

• Veneer can be reinforced with optional Seismiclip® Interlock System (HB-213 S.I.S. )
• Veneer can be reinforced with optional Seismic Hook (HB-213 SH Seismic Veneer Anchor )
• Veneer can be reinforced with optional Welded Seismic Clip (Seismic Clip 300C w/HB-213 )

NOTES:

• H&B recommends 16" x 16" spacing
• Legs fabricated to accommodate up to 6" thick insulation and/or wallboard combination (state thickness when ordering)
• Also available:HB-200-X : features three pronged punch-outs that project from the back of the anchor. The prongs prevent positive wind-loads from crushing the wallboard by transferring these loads to the back of the stud.
• Optional: HB-213 Washer to hold insulation to back-up

Submittal Sheets

• HB-213 Adjustable Veneer Anchor Submittal

Safety Data Sheets (SDS)

• Hot Rolled Carbon Steel
  
• Galvanized Steel Sheet Items
• Brite Basic Wire
• Hot Dip Galvanized Coating
• Stainless Steel